FAQ：Spec
FAQ：Spec
- What is the OV/UV behavior in the shaded area of the timing chart in the R3152 datasheet?
- Regarding the output current of the NJM2871A, the maximum value is stated to be 150mA, but is there a minimum value?
- Do NJU7704 and NJU7705 have delay time when manual reset function is released?
- The data sheet for the FB pin of the NJM2369 says that the source current is 40 to 200µA, but does this pin have a built-in pull-up resistor?
- What is the range of NJM17431 output voltage in operation temperature range?
- What is the threshold voltage and maximum voltage of the Ct terminal of the NJU2103A?
- How much is the value of CE pin's pull-down resistance of RP122?
- Is the stand-by current 1.0µA of R1524 series maximum value on operation temperature?
- Release delay time when Cd pin of R3116 is open.
- Release delay time when Cd pin of R3118 is open.
- What is the variation of detect delay time of R3118 series.
- What is the difference of NJM78 series?
- θja and Ψjt of NJM78L00S series?
- θja and Ψjt of NJM78M00 series?
- Does the frequency response characteristics of the output voltage change depending on the output resistor value?
- What is the recommended pattern width of NJL5820R.
- What is the wavelength of LED in NJL5820R?
- What is the difference between NJL5901 series and NJL5902 series?
- I would like to use the output of the OUT pin of the NJL5830R for switching the circuit in the latter stage, but what is the allowable current on the OUT pin?
- What is the Quiescent current (the CONTROL terminal voltage (Vcont) = 0V) of the NJM2387 ?
- How long is the detection delay(td) of R3111 series.
- The RESET output pulse width (tPO) is guaranteed as follows with CT=0.01μF. In addition, the data sheet provides the calculation formula
- Is NJU7890_"High accuracy attenuation factor error ±1.0%" not affected by internal resistance variation?
- What is the Min./Typ./Max. value of detection delay (treset) of R3119 and R3120?
- What is the Min./Typ./Max. value of detection delay (treset) of R3152 ?
- Is the /RESET pin of the NJU2103A pulled up to V+ with a resistor inside the IC?