FAQ：Operational Amplifier
FAQ：Operational Amplifier
- Can position sensor products (NJL5820R, NJL5821R, NJL5822R) be used for origin (Zero) detection ?
- Is it possible to use position sensor products (NJL5820R, NJL5821R, NJL5822R) with resolutions other than the recommended resolution?
- In a 4-circuit, 6-circuit, or other multi-circuit operational amplifier, what should I be designed with the free pins of unused circuits?
- An input terminal of Operational amplifier or Comparator installed an ESD protection diode. Could I apply an electrical current to ESD protection diode on operating it?
- Is an op amp or comparator how to apply supply voltage sequence?
- What is input bias current of OP-Amp or Comparator?
- Is the maximum value of the input offset voltage of the operational amplifier and comparator expressed in absolute value?
- Are there any caution points using the J-FET op amp?
- Why does it occur op amp output phase-reversal phenomenon?
- The input resistance of the operational amplifier is low and the input voltage seems to drop. <br> How much ohms is the value of the input resistance of it?
- Does Nisshinbo Micro Devices available Rail to Rail Op Amp?
- The maximum input bias current for operational amplifiers and comparators is 50nA (example), but is this expressed in absolute values?
- Could I get IBIS model for an analog IC( op amp or regulator )?